EN
OPERATOR'S MANUAL
51
EXECUTION OF THE
CYCLE
Take, for example, the execution of Thermal disinfection (D90) cycle, which includes the
following phases:
- Pre-washing
- Washing
- 3 Rinses
- Heating
- Thermal disinfection (from thermal disinfection temperature reaching to drainage
included).
- Drying:
1. Temperature in the chamber
2. A0
3. Disinfection time (fixed until
thermal disinfection start, then
decreasing till the end)
The Pre-washing cycle has only the Pre-washing phase.
CYCLE OUTCOME
At the end of the cycle it is important to check the process outcome.
If message "CYCLE COMPLETED" is displayed, this means that the cycle ended correctly
without interruptions due to any alarms, and the material disinfection is ensured.
If the cycle FAILED it did NOT end correctly and the code of the alarm that interrupted the
cycle appears. Refer to 'Alarms' appendix.
NOTE
AT THE END OF THE CYCLE, IF THE DOOR IS NOT OPENED, AN
ACTIVE VENTILATION PHASE OF THE WASHING CHAMBER IS
ENABLED TO REMOVE HUMIDITY RESIDUES FROM THE LOAD.
SUCH FUNCTION AUTOMATICALLY ENDS AFTER ABOUT 2 HOURS OR
WHEN THE DOOR IS OPENED.