EN
OPERATOR'S MANUAL
49
DRYING FUNCTION
A function allowing to adjust the drying time of each cycle is available.
NOTE
"STANDARD" DRYING ALLOWS TO REMOVE WATER RESIDUES FROM
A COMPLETE LOAD OF METAL INSTRUMENTS.
TO OBTAIN BETTER DRYING PERFORMANCE, IT IS RECOMMENDED
TO SET A LONGER TIME DEPENDING ON THE TYPE OF LOAD.
After selecting the desired cycle, hold the following key pressed to set the drying time:
Set total drying minutes of the process. The minimum value that can be set is the standard
value foreseen for the selected process; if 0 (zero) value is set, drying phase is deactivated.
The selected value appears near the key.
Press "Enter" to confirm the set value.
Activate the cycle.
NOTE
THE VALUE REMAINS STORED SO, IF UPON NEXT CYCLE RUN YOU
DO NOT WISH TO ACTIVATE DRYING, PRESS THE DRYING ICON