25
Testing the Mobilarm V100
Performing a Short Test
The short test only checks the selected function and will cease
testing once it is complete.
Ensure the
1
ARMING SWITCH
is in the
[OFF]
position.
Press and hold the black
2
TEST BUTTON
on the
rear of the unit for 3 seconds.
This activates the test sequence.
The
Ŷ
STROBE
ÀDVKHVTXLFNO\IRUVHFRQGV
Listen for the automated message “V100 test
3
menu, run all tests” followed by a beep.
Press the
4
TEST BUTTON
within 2 seconds to
navigate to the desired test.
Each button press will skip to the start of the next test in the
sequence.
E.g. To perform the third test in the sequence, press the
TEST BUTTON
3 times.
Table 2: Mobilarm V100 Test Indications (
Î
27
)
Once the Mobilarm V100 has completed the
5
selected test, the device will turn off.
Warning
!
Only performing short tests is not recommended because
Ŷ
not all functions are tested and therefore may compromise
the operational status and safety of the device.
Perform a full test every 3 months to ensure that all functions
Ŷ
of the Mobilarm V100 are operating normally.
v100_user_v5.indd 25
25/06/2009 2:17:08 PM
