Mobeye ThermoGuard TwinLog CML2255, Portal User Manual

Page: 17 / 28

16
5. POSSIBLE SETTINGS
The Mobeye CML2255 settings are prepared in the portal, in the "Options" block, and
then retrieved by the device during a synchronization session. The factory setting for
the security code is '1111'. All settings are saved and stored in the unit, even when the
unit is not powered or the batteries have been removed.
5.1 INSTALLATION CODE
For configuration activities the installation code of the Mobeye CML2255 must be used.
The initial (security) code is ‘1111’. The code can be changed in the options. Note: the
code is only visible when changing the settings.
5.2 ALARM PHONE NUMBERS
The Mobeye CML2255 is able to directly call to up to 5 phone numbers. These may be
different numbers than the (unlimited number of) contacts who will receive SMS text
messages and/or e-mails. It is not required to enter phone numbers.
5.3 SET A MINIMUM AND/OR MAXIMUM TEMPERATURE LIMIT
A separate high and/or low limit for the temperatures can be set for each sensor. The
limits can be set between -35 and +70 ºC, with one decimal. Negative values are set by
a “-” before the value.
5.4 CALL ON/OFF
Even if the alarm telephone numbers are set in the options, the calling process can be
suppressed. By turning off the CALL, the unit will only send the notification via the
Mobeye Internet Portal. The default value is set to ON.
5.5 TEMPERATURE DELAY TIME
The temperature delay time defines the duration a temperature limit is violated before an
alarm is initiated. If the temperature returns to the non-alarm status within the delay