Mobeye ThermoGuard CM2200, User Manual

Page: 20 / 32

19
triggered when the connection between the input terminals is broken. The default input
type is set to NO.
SMS command input type input 1:
TYPEIN1:NO or TYPEIN1:NC
SMS command input type input 2: TYPEIN2:NO or TYPEIN2:NC
example: 1111 TYPEIN1:NC
5.10 INACTIVE TIME
The “inactive time” defines the time an input is not active after an activation. During the
inactive time, no new alarm message will be sent. Only when the input returned to the
non-alarm status, gets activated again and remains active, an alarm will be sent yet after
the inactive time. If
the time is set to “0” (minutes), the input will be active again
immediately after returning to the non-alarm status. The time can be set between 0 and
60 minutes. As default, the inactive time is set to
“0”.
SMS command inactive time input 1:
INACTIVEIN1:
SMS command inactive time input 2: INACTIVEIN2:
example: 1111 INACTIVEIN2:45
5.11 ALARM REPEAT TIME
In order to emphasize the urgency of the alarm messages, all alarms can be repeated.
As long as the input has not returned to the inactive status, the SMS alarm will be
repeated after the ‘alarm repeat time’. The time can be set between 0 and 999 minutes.
As default the alarm repeat time is set to 0 minutes.
SMS command alarm repeat time:
REPEAT:
example: 1111 REPEAT:20
5.12 POWER FAILURE DELAY TIME
If the Mobeye ThermoGuard is powered externally and the power fails it can notify the
contact person(s). The power failure delay time defines the time between the initial
power failure and the alarm notification. If the power is restored within the delay time, no