Press the On/Off switch (10) for 2 seconds to turn the unit on/off. The small red power-on
LED (5) indicates the mode of operation as determined by the Reference Dial (9) position:
2.1 Powering Up
LED flashing
– Tilt compensation feature is on. The unit automatically accounts for the
dipper arm tilt to indicate correct digging depth. Reference Dial (9) not in Off position.
LED solid
– Tilt compensation feature is off. The unit does not account for the dipper arm
tilt when indicating correct digging depth. This mode is less accurate. Reference Dial (9) in
Off position.
On power up, the sensor will do an LED test sequence, activating in turn the red, green
and amber LEDs. It will then show the current accuracy selection by briefly flashing the
appropriate LED pattern (see section 2.4).
2.2 Mounting and Setting Up
2. USING THE LASERGUIDE
© Copyright MOBA Mobile Automation Australia Pty Ltd
Using the Laserguide
8
IN-TRENCH SETUP
Figure 3
