Now we need to determine where this module is going. The front circuit board is a
VERY tight fit. We need to make some room. The easiest way to get an idea of the
problem is to test fit where it will be going.
I have several types of racks in the lab and I have found that the Doepfer/TipTop
rails to be the tightest fit. So I am using them as my guide for this manual. You
might be using vector rails in a custom unit, if so, your tolerances will be looser
and you might have no size issues.
Just because you have no issues now, does not mean the next guy who you sell
your Minitaur to will have no issue, so please keep that in mind while performing
the next steps!
Step#4
Step#4
If you plan to never sell your Minitaur, then NO WORRIES. Just custom fit to your
rack dimensions and you are good to go.
Test your final rack opening by taking a
couple of washers and nuts and attach the
front panel. This is temporary.
Now place into your opening and you might
immediately see a couple of issues.
The cable might be hitting on top and the
circuit board might be getting hung up on the
bottom. In these pics I am using TipTop rails.
Again if you have no problems and you have
no plans on selling it, than you are home free!
If you do have problems, let's move to the next
steps to see what we can do to eliminate them!
