Step#2
Step#2
If you have a pair of 'helping hands' this step is
much easier. If not you can tape the connector
to an edge of a table.
Remove the ends of insulation and solder them.
Then add solder to the ends of the header
connector.
Now solder the ends of the wires to the header
connector so it looks as pictured to the left.
Using a set of wire cutters, cut the two off from
the end so they are separated like pictured to the
left.
Prep the other end of the cable and remove the
insulation from the ends and solder them as
pictured.
The missing wire from the connector is there on
purpose. It will act as a 'key' so you know
which way to insert the USB connector.
