System Two LED Installation and Service Manual (1003385 Rev. C)
Page 42
Section 5
Adjusting the Brakes for the Extension Arm (cont)
Figure 19: Mounting the right-hand cover panel to the
Extension Arm
Mounting the right-hand cover panel to the
extension
Mounting the rear cover panels to the Extension
Arm
The mounting of the cover panels is illustrated using
the example of the System Two LED central axis S1
version. The installation procedure for further versions
is identical.
Follow the safety instructions on Page 56.
Mounting the left-hand cover panel to the
Extension Arm
1. Position the left-hand Extension Arm cover panels
③
on the Extension Arm such that the top cover
panel
①
sits in the Extension Arm cover
③
.
2. Tighten the left-hand Extension Arm cover panel
③
using 2 PT Torx screws
②
.
Mounting the right-hand cover panel to the
Extension Arm
1. Place the right-hand Extension Arm cover panel
③
into the left-hand Extension Arm cover panel.
Make sure that the rear latches
②
engage with
each other in a 90° angle and then close the
Extension Arm cover panels like a hinge.
2. Screw the right-hand Extension Arm cover panel
③
onto the top and bottom sides of the left-hand
Extension Arm cover panel using 2 PT Torx screws
①
.
3. Check that the Extension Arm cover panels are
securely in place;
The Extension Arm cover panels must engage
tightly with each other without gaps.
The 2 PT Torx screws
①
– must be tightened.
Figure 20: Mounting the left-hand cover panel
to the Extension Arm