System Two LED Installation and Service Manual (1003385 Rev. C)
Page 38
Section 4
Mounting the Light Head to LCH Spring Arm
Figure 14: Mounting the Light Head to an LCH Arm
Note: For In-Light Camera Light Heads, run the
wires from the yoke pivot into the arm before
installing the Light Head.
Installing the Light Head into the LCH Spring Arm
requires two people to position the Light Head yoke
pivot into the receptacle.
Use the detail illustrations on the previous page
*** Risk of the Light Head dropping ***
Align the yoke pivot to the receptacle on the LCH
Spring Arm.
Lubricate the pivot on the Yoke (going into the
Spring Arm) with white grease through the fitting
aperture of the securing segment
②
.
Carefully insert the pivot into the receptacle until it
stops.
Once the Light Head yoke pivot is in the LCH Spring
Arm you are ready to install the securing segment
②
.
Mounting the securing segment
1. Lubricate the securing segment
①
with white
grease.
2. Lubricate the pivot of the Light Head/Yoke Assembly
or the Monitor Cradle with white grease.
3. Insert the Pivot on the Light Head/Yoke into the
Spring Arm assuring the groove in the yoke pivot
aligns with the securing segment slot in the arm.
Once alignment is achieved, insert the securing
segment
①
.
4. Check that the securing segment
①
is securely in
place;
The Light Head must rotate freely.
Moving the segment securing device
5. Re-tighten the optional brake screw
6. Push the segment securing device
②
backwards
and screw it on using 1 Phillips recessed head
screw
③
.
Adjusting the vertical lift and the optional brake
7. Adjust the vertical lift of the Spring Arm as described
in Section 5;
Mount the cover panels to the Spring Arm.