System Two LED Installation and Service Manual (1003385 Rev. C)
Page 36
Section 4
Mounting the Light Head to L17 Spring Arm
Figure 12: Mounting the Light Head
Note: For In-Light Camera Light Heads and Monitor
Cradles, run the wires from the yoke pivot into the
arm before installing the Light Head.
Installing the Light Head or the Monitor Cradle to
the L17 Spring Arm requires two people to position
the Light Head yoke or Monitor Cradle pivot into
the receptacle.
Use the detail illustrations on the previous page
Remove the Plastic Covers from the Spring Arm
Position the yoke pivot directly under the receptacle
Lubricate the pivot on the Yoke (going into the
Spring Arm) with white grease through the fitting
aperture of the securing segment
②
.
Carefully slide the pivot into the receptacle.
*** Risk of the Light Head dropping ***
Once the Light Head yoke pivot is in the L17 Spring
Arm you are ready to install the two securing
segment
②
.
Mounting the first securing segment
1. Lubricate the securing segment
②
with a White
solid lubricant paste grease (white grease)
2. Route the segment securing device
①
slightly
downwards.
To do this, cover the second securing segment on
the opposite side with your hand in order to prevent
it from dropping out of the Spring Arm.
3. Place the securing segment
②
and route the
segment securing device
①
towards the top and
then rotate it approximately 90° to the left.
The cutout
③
in the segment securing device
①
must protrude over the optional brake screw or
brake screw hole
④
.
4. Check that the securing segment
②
is securely in
place;
The Light Head/Yoke Assembly or the Monitor
Cradle must rotate freely.
Checking the second securing segment
5. Dismantle and check the second securing segment
as described in Section 6.
6. Re-mount the second securing segment.
Adjusting the vertical lift and the optional brake
Adjust the vertical lift of the Spring Arm as described
in Section 5.
Mount the cover panels to the Spring Arm.