System Two LED Installation and Service Manual (1003385 Rev. C)
Page 35
Section 4
Preparing the L17 Spring Arm
Figure 11: Preparing the L17 Spring Arm
The Figure shows a simplified illustration of the
Spring Arm [5] without cables or Light Head.
*** Risk of the Light Head dropping ***
The Light Head is kept in its position in the Spring Arm
by 2 securing segments. If both securing segments are
dismantled simultaneously from the Spring Arm, there
is a risk of the Light Head dropping out of the Spring
Arm and causing severe injury;
Dismantle the securing segments one at a time.
Dismantling the first securing segment
1. Rotate the segment securing device
①
approximately 90° to the right, route it slightly down-
wards and then remove the first securing segment
②
.
To do this, cover the second securing segment on
the opposite side with your hand in order to prevent
it from dropping out of the Spring Arm.
2. Remove the second securing segment in the same
manner.
3. Route the segment securing device
①
back
upwards.