System Two LED Installation and Service Manual (1003385 Rev. C)
Page 40
Section 5
Section 5: Adjustments
Adjusting the Brakes for the Extension Arm
Figure 16: Dismantling the right-hand cover panels from
the Extension Arm
Figure 17: Dismantling the left-hand cover panel from the
Extension Arm
To adjust the brakes, the cover panels must be
dismantled from the corresponding Extension Arm [4].
The dismantling of the cover panels is described using
the example of the System Two LED central axis S1.
The installation procedure for further versions is
identical.
Follow the safety instructions on Page 56.
Dismantling the cover panels on the right-hand
side from the Extension Arm
1. Unscrew the 2 PT Torx screws
①
from the top and
bottom sides of the left-hand Extension Arm cover
panel.
2. Insert a suitable slotted screwdriver into the fitting
aperture in the right-hand Extension Arm cover from
below and disengage it by gently pushing it in.
3. Insert a suitable slotted screwdriver into the fitting
aperture of the left-hand Extension Arm from above
and disengage it by gently pushing it in.
4. Disengage the right-hand Extension Arm cover
panel
④
from the edge of the connection of the 2
Extension Arm cover panels.
5. Gently remove the right-hand Extension Arm cover
panel from the Extension Arm [4].
To do this, gently disengage the latches
③
.
Dismantling the left-hand cover panel from the
Extension Arm
1. Unscrew the 2 PT Torx screws from the left-hand
Extension Arm panel.
2. Gently remove the left-hand Extension Arm cover
②
from the Extension Arm [4].