MK Diamond Products 160028, Owner'S Manual & Parts List

Page: 27 / 40

27
"Rodding" cooling channels is performed by inserting a small wire rod through the cooling
inlet on top of the Blade Guard and directing the rod out through each of the cooling
flow tubes located on the underside of the Blade Guard. The cooling channels should be
"rodded" until all ports are free of foreign debris.
NOTE:
(D)
Remove the Blade Guard Intake
Fitting.
(E)
Clean the Blade Guard Intake
Fitting.
(F)
Locate the Blade Guard Cooling
Channels.
(G)
Rod Cooling Channels and
recheck flow.
MOVABLE CUTTING TABLE DOES NOT MOVE CORRECTLY
(A)
Check the Guide Bar and Roller
Wheel Guide Frame is clean -
clean if dirty.
(B)
Check the Movable Cutting
Table Roller Wheels for wear
replace if necessary.
MK-377EXP SAW TROUBLESHOOTING