Mitutoyo MF 1010C Series, User Manual, Page: 63 / 88

5. Troubleshooting
No. 99MBA091A
5-3
5.3 Illuminator and Concerned Matters
Symptom Check point Remedy
1)
Dark or unlighted
Transmitted
illuminator/vertical
reflected
illuminator [LED illuminator]
1) The illuminator is dark or unlighted.
[Halogen illuminator]
1) Is the halogen bulb OK?
2) Does the halogen bulb meet the
specification?
[Common to LED / Halogen illuminator]
1) Is the power cord disconnected?
2) Is the main unit connected to the
illuminator properly?
3) Is the main power switch turned on?
4) Is the auxiliary power switch turned
on?
5) Is the cable for each illuminator
properly connected?
6) Is the cooling fan of each illuminator
working?
7) Is the installation environment of the
microscope kept at a proper
temperature?
8) Is the illuminator energy saving
activated?
1) If the symptom is not solved
after disconnecting the
illuminator once and
reconnecting it, replace
the LED illuminator. (Contact
your dealer or the nearest
Mitutoyo sales office.)
1) Replace the halogen bulb.
2) Replace the bulb with new bulb
with the same rating.
1) Disconnect the illuminator once
and re-connect it securely.
2) Disconnect the illuminator once
and re-connect it securely.
3) Turn on the main power switch.
4) Turn on the auxiliary power
switch.
5) Disconnect the cable once and
re-connect it securely.
6) Restart the power of the
microscope. If the same
symptom occurs, contact
Mitutoyo Service Center.
7) Turn off the power of the
microscope, then turn it on
again at least 10 minutes later.
8) Set the “ F10 ” counter
parameter to “ 0:None ”.
(Refer to “ About parameters ”
explained in selection 1.2.4
“ DRO Counter Unit ”,Section
1.2 “ Name and Function of
Each Unit”.)
2
）
Disabled optional
illuminator at use
of vision unit
1) The optional illuminator does not
work with QSPAK VUE appropriately.
1) Check whether the control
cable of the external illuminator
is connected to the counter unit.
(Refer to “1.2 Name and
Function of Each Part” - “1.2.4
Counter unit”.)
3) Ceaseless buzzer
1) The buzzer keeps sounding from the
controller.
1) Refer to “5.4 Error Messages
and Remedies” – “5.4.2
Illuminator and concerned
matters”.