Mitutoyo 542-071, User'S Manual / Instructions For Use

Page: 29 / 76

3 Setting Parameters
15
No. 99MBC109B
No. Setting item
Description/Allowable values
(the values in bold indicate the default value)
Counter model
P Z S D
15
Smoothing Averages the counter value and then displays it. (This
reduces fluctuation of the lowest-order digit.) You can
specify the number of measurements to average.
● ● ● ○
0: None
1: Display the average of 16 measurements
2: Display the average of 32 measurements
16 Peak value Preset Sets whether to perform presetting based on the peak
value during Peak mode.
● ● ● ●
0: Disabled
1: Enabled
18 Speed sampling
cycle
(EH-102P/Z/S
only) In Display mode selection, selects the sampling cycle
when Speed display is selected.
● ● ●
0: 0 ms
2: 100 ms
1: 50 ms
19 Digimatic input
WAIT Sets the wait time for the Digimatic input signal.
Change this when the Counter cannot read the input
signals from a Digimatic device.
●
0: No WAIT
2: 200 ms WAIT
1: 100 ms WAIT
20 Tolerance output/
BCD output swi-
tchover*
1
Switches between tolerance judgment result output
and BCD output.
● ● ● ●
0: 3-step tolerance
2: BCD output
1: 5-step tolerance
21 BCD output logic* 1 Selects whether to use positive logic (0) or negative
logic (1) for BCD output.
● ● ● ●
0: DATA [L] (sign H) 1: DATA [H] (sign L)
24 RS-232C/USB/
Digimatic output
switchover*
2
Selects which output terminal to use.
● ● ● ●
0: RS-232C
2: Digimatic
1: USB
25 Data transfer
speed*
2
Selects the data transfer speed for RS-232C.
● ● ● ●
0: 4800 bps
2: 19200 bps 1: 9600 bps
26 Parity check*
2
Selects the parity check method for RS-232C.
● ● ● ●
0: None
2: Even numbered
1: Odd numbered
27 Data bit* 2 Selects the length of the data bit for RS-232C.
● ● ● ●
0: 7 bit 1: 8 bit
28
Output trigger* 2 Selects the output trigger method for RS-232C.
● ● ● ●
0: RS-232C command (normal state)
1: RS-232C command (with channel synchronization
function)
2: HOLD trigger