3 Setting Parameters
22
No. 99MBC109B
3.6
Overview of Setting Parameters
This section gives an overview of setting parameters.
Tips
• The following figure does not show the steps for setting parameters.
• When setting parameters, each time you press [P.SET], the parameter number will
advance from 00. When the number advances to the last number, it then returns to 00.
• When 1 (CEL-specific parameters setting) is selected as the set value for parameter
number 00, the parameter number will switch to parameter number 40 for 2-axis models,
and to parameter number 41 for 1-axis models. When the parameter number advances to
42, it will return to 40 for 2-axis models, and to 41 for 1-axis models.
• Be sure to set the parameters enclosed within a solid line. Perform the parameter settings
enclosed with a dashed line as necessary.
No
Yes
No
Yes
EH-102Z?
EH-102S?
Begin setting
(Parameter number 00 = 0)
[05] Origin detection function
[09] Unit system selection
[11] Counter direction setting
[12] Linear Gage
resolution
Continued on the next page
[10] Output signal pitch
Basic
parameters
For details about basic parameters, see "3.2 Basic Parameters" (page 12).
Summary of Contents for 542-071
Page 14: ...xii No 99MBC034B...
Page 20: ...1 Overview 6 No 99MBC109B MEMO...
