32
<<Remove the main board >>
<<Remove the power supply board>>
Steps 1)
Pull the front case switch operation
part to the outside, detach the main
board cover side switch button (convex
part) fittings, and remove the main
board cover assembly.
(See Picture 7)
2) Release the main board click fittings (4
points on the bottom), and remove the
main board.
(See Pictures 8 and 9)
Steps 1)
Detach the connectors in the power
supply board (P10, 11, 12, 13, 2, 3, 5,
1---8 connectors), and remove the
power supply board.
(See Picture 6)
Picture 8
Fastening click fittings
Picture 9
Picture 7
4. Remove the rear case
Repairable
parts
Blower fan
Temperature/humidity sensor,
solenoid valve, float switch,
thermal overcurrent cutoff
Steps 1)
Following the sequence in Procedures
1-3 above, remove the water tank,
front panel and front case assembly.
2) Remove the rear case setscrews (6).
(See Picture 10)
3) Hold the bottom of the rear case and
pull it to the outside, release the
bottom fitting and then push upward
while lifting the handle. Release the
handle slip prevention fitting, and
remove the handle.
(See Picture 11)
4) Pull the upper part of the rear case to
the outside, and release the fitting
between the screw fastening boss and
blower fan assembly side fastening
guide (one on each side).
(See Picture 12)
5) Lift the rear case up, and remove by
passing it under the louvre.
(See Picture 13, 14)
Fittings
(one on each side)
Picture 12
Temperature/humidity
sensor
Louvre
Picture 13
Handle
Picture 11
Rear panel
setscrews
Picture 10
Summary of Contents for MJ-E16S-S1
