Mitsubishi 6M60-TL, Service Manual

Page: 96 / 330

11-60
• Tighten the flywheel mounting bolts to a torque of 98 N·m {10
kgf·m}.
• Further tighten the bolts in the following procedure.
• Turn the holder of counterclockwise to preload the built-
in spring.
• Set such that the rod (extension) is pressed against
by the force of the spring.
• Align any line on the holder scale with any line on the socket
scale. (This will be used as the reference point = 0
°
.)
•
From the reference point, turn the socket by 150
°
clock-
wise. Each division on the socket scale represents 5
°
.
• After tightening the bolt within the plastic region, make a
punch mark on the bolt head for subsequent identification.
CAUTION
• The bolts should be tightened within the plastic region.
Never tighten them further than the specified angle.
+10
°
0
°
FLYWHEEL