Mitsubishi 6M60-TL, Service Manual

Page: 289 / 330

54-20
Disassembly: Yoke and brush holder
• Use the following method to remove the yoke and brush holder
in order to prevent the commutator of the armature from being
damaged by the brushes.
• Lift the brushes away from the commutator and hold them lift-
ed by applying the brush springs against the sides of the
brush springs.
• Pull part A of each brush spring and pull up the brushes.
• Hold the brushes in position with the brush springs as illustrat-
ed.
• Remove the yoke and brush holder.
Disassembly: Gear shaft and internal gear
• Remove the E-rings and then the gear shaft and internal gear
from the overrunning clutch.
Proceed as follows if the gear shaft cannot be removed due to
interference of the splined section of gear shaft with internal
parts of the overrunning clutch.
• Press the gear shaft against the overrunning clutch.
• Turn the gear shaft approx. 1/8 of a turn to change the posi-
tion of splined section.
Disassembly: Front bearing
#930 STARTER