Mitsubishi MOTORS Outlander PHEV 2016, Owner'S Manual, Page: 240 / 490

A- Control state
There are 3 control states as below.
LIMIT OFF
When the Speed Limiter is in
STANDBY, the vehicle speed can ex-
ceed the set speed
LIMIT
When the Speed Limiter is in opera-
tion. The vehicle is controlled in order
not to exceed the set speed.
OVER LIMIT
When the vehicle speed is exceeding
the set speed by more than about
3 km/h (2 mph)
B- SPEED LIMITER ON indication
When the Speed Limiter is started up,
the Speed Limiter’s symbol appears.
C- Set speed
Set speed appears if it is stored.
To start up
E00633501025
First of all, press the ON/OFF switch in order
to power up the Speed Limiter when the op-
eration mode in ON.
The Speed Limiter indication will be ap-
peared in the combination meter.
To activate
E00633601055
Accelerate or decelerate to your desired
speed, and push down the SET - switch (B).
the Speed Limiter memorizes the current ve-
hicle speed when you release the SET -
switch (B). Now, the Speed Limiter starts
controlling in order not to exceed the set
speed.
If the current vehicle speed is lower than
about 30 km/h (19 mph) (settable minimum
speed), the set speed is set at about 30 km/h
(19 mph).
The set speed is displayed in the combination
meter.
And, control state “LIMIT” is displayed in
the combination meter.
To increase the set speed
E00633700017
By using the RES + switch
E00633801044
Push up the RES + switch continuously.
Then the set speed displayed in the combina-
tion meter is gradually increased.
If the set speed reaches your desired speed,
release the RES + switch (C).
The set speed is increased each about 5 km/h
(3 mph) per about 0.5 second.
If a driver wants to increase the set speed a
little, push up RES + switch for less than
about 0.5 second and release it.
Speed Limiter*
7-40
OGGE16E1
Starting and driving
7