Mitsubishi MOTORS Outlander PHEV 2016, Owner'S Manual, Page: 123 / 490

To install
1. Remove any foreign material in or
around the connectors and ensure the ve-
hicle seat belt is in its normal storage po-
sition.
2. Remove the head restraint from the loca-
tion in which you wish to install a child
restraint.
Refer to “Head restraints” on page 5-05.
3. When installing a child restraint system
in the front passenger seat, adjust seat
slide to its most rearward position.
4. Push the child restraint system’s connec-
tors (A) into the lower anchorages (B) in
accordance with the instructions provi-
ded by the child restraint system’s man-
ufacturer.
For easier access to the rear seat lower
anchorage, the rear seatback may be re-
cline rearward. After it is security fas-
tened, adjust the seatback to 4 steps for-
ward from most reclined position.
A- Connector
B- Lower anchorage
C- Vehicle seat cushion
D- Vehicle seatback
If your child restraint system has a sup-
port leg, make sure that there is a sup-
port leg at the stable position on the
floor. If your child restraint system re-
quires the use of a tether strap, fasten the
tether strap in accordance with step 5.
5. Latch the tether strap hook (E) of the
child restraint system to the tether an-
chorage bar (F) and tighten the top tether
strap hook so it is securely fastened.
Front passenger seat
Rear seat
NOTE
l If it is difficult to latch the tether strap hook
in the rear seat, turn the hook sideways.
6. Push and pull the child restraint system
in all directions to be sure it is secure.
Child restraint
5-27
OGGE16E1
Seats and seat belts
5