Mitsubishi MOTORS Mirage 2012, Owner'S Manual

Page: 109 / 250

l Remove the object or additional key from the
the keyless operation key before inserting the
key into the key slot. The vehicle may not be
able to receive the registered ID code from
the registered key. Therefore, the engine may
not start and the operation mode may not
change.
Keyless operation key reminder*
E00632600022
If the operation mode is in OFF and the driver’s
door is opened with the keyless operation key in
the key slot, the warning lamp will blink and the
outer buzzer sounds for approximately 3 seconds
and the inner buzzer sounds for approximately 1 mi-
nute to remind you to remove the key.
Auto Stop & Go (AS&G) system*
E00627400080
The Auto Stop & Go (AS&G) system automatical-
ly stops and restarts the engine without operating
the ignition switch or engine switch when the vehi-
cle is stopped, such as at a traffic light or in a traf-
fic jam, to reduce exhaust gases, increase fuel effi-
ciency.
CAUTION
l If the vehicle will be stopped for a long
time or if you will leave the vehicle unat-
tended, stop the engine.
NOTE
l The accumulated time the engine has been
stopped by Auto Stop & Go (AS&G) system
is displayed in the multi information display.
Refer to “AS&G monitor*” on page 3-05.
Automatically stopping the engine
E00627500124
The Auto Stop & Go (AS&G) system is automati-
cally activated when the ignition switch is turned to
the “ON” position or the operation mode is put in
ON.
You can deactivate the system by pressing the “Au-
to Stop & Go (AS&G) OFF” switch.
Refer to “To deactivate” on page 4-18.
When the Auto Stop & Go (AS&G) system will op-
erate, the indication lamp will turn on to inform the
driver.
Indication lamp
[For vehicles with M/T]
1. Stop the vehicle.
2. While depressing the brake pedal, fully de-
press the clutch pedal and place the gearshift
lever in the “N” (Neutral) position.
3. Release the clutch pedal. The engine will
stop automatically.
Starting and driving
4-15
OA0X13E4
4