Mitsubishi MOTORS Mirage 2012, Owner'S Manual

Page: 144 / 250

TREBLE (Treble tone control)
Press the sound control button either or to
select the desired treble level.
FADER (Front/Rear balance control)
Press the sound control button either or to
balance the volume of sound from the front and the
rear speakers.
BALANCE (Left/Right balance control)
Press the sound control button either or to
balance the volume of sound from the left and the
right speakers.
NOTE
l The sound control mode will be cancelled
when the another mode is selected or no ad-
justment is performed for more than 10 sec-
onds.
l In a two-speakers vehicle, keep the FADER
setting in the middle position. Since no rear
speakers are connected, adjusting the FAD-
ER setting towards the “REAR” side will re-
sult in a loss of sound output.
Radio control panel and display
E00708901273
1- RADIO (FM/MW/LW selection) button
2- PWR (On-Off) switch
3- Display
4- Seek (Down-seek) button
5- Seek (Up-seek) button
6- Memory select buttons
To listen to the radio
E00709000926
1. Press the PWR switch or the RADIO button
to turn ON the radio.
Press and hold the PWR switch for 2 seconds
or longer to turn OFF the radio.
2. Press the RADIO button to select the desired
band.
3. Press the seek button or memory select but-
tons to tune into a radio broadcasting station.
To tune the radio
E00709100679
Manual tuning
The frequency changes every time the seek button
is pressed. Press the button to select the desired ra-
dio broadcasting station.
Automatic tuning
After keeping the seek button depressed until it
beeps, release the button, and the selected station re-
ception will start.
To enter frequencies into the memory
E00716101229
Manual setting
You can assign to the memory select buttons a max-
imum of 18 stations in the FM band (6 FM1, 6
FM2 and 6 FM3 stations) and 6 stations each in the
MW and LW band. (Stations already assigned to
the memory select buttons are replaced by any new-
ly assigned stations.)
Follow the steps described below.
1. Press the seek to tune to the frequency you
wish to keep in the memory.
2. Press one of the memory select buttons until
it beeps.
The sound will be momentarily interrupted
while the frequency is being entered into the
memory. The number of the button matching
the entry in the memory as well as the fre-
quency is displayed.
3. The preset memory setting is retrieved by
pressing the button and then releasing it with-
in 1 second.
Automatic setting
With the method, all manually set stations in the
band currently selected for reception are replaced
with stations in the same band that are automatical-
ly selected in order of signal strength. The radio au-
tomatically selects 6 stations in the FM band (FM3
station only) and 6 stations each in the MW and
LW band.
Follow the steps described below.
For pleasant driving
5-14
OA0X13E4
5