Mitsubishi MOTORS Laser 1991, Service Manual, Page: 237 / 320

Vertical center
line ahead of
right headlight
Vertical ‘center
Vehicle line ahead of
axis
left headlight
High intensity
area
High intensity
area
I Vertical center line
A: mm
HEADLIGHT AIM PREPARATION
Place vehicle on a known level floor 7.6 from aiming
screen or light colored wall. Four lines of adhesive tape or like
are required on screen or wall:
1. Position a vertical tape so that it aligned with the vehicle
center line.
2. Position a horizontal tape with reference to center line of
headlight.
3. Position a vertical tape on the screen with reference to the
center line of each of headlights.
VISUAL HEADLIGHT ADJUSTMENT
A properly aimed lower beam will appear on the aiming
screen 7.6 (25 feet) in front of the vehicle. The shaded
area as shown in the illustration indicates
zone.
2. Adjust low beam of headlights to match the low beam
pattern of the right and left
Measure the luminous intensity of headlights with a photometer
in accordance with the instruction manual prepared by the
manufacturer of the photometer and make sure that the luminous
intensity is within the following limit.
NOTE
(1) ‘When measuring the luminous intensity of headlight, keep
the engine at 2,000 rpm and have the battery charged.
(2) If there are specific regulations for luminous intensity, of
headlights in the region where the vehicle is operated, make
sure that the intensity conforms to the
such
regulations.
1. Place vehicle on a known level floor 7.6 (25 feet) from
aiming screen or light colored wall.
2. Use adjusting screw to adjust the top end of high intensity
zone to dimension A.