Mitsubishi MOTORS Laser 1991, Service Manual, Page: 202 / 320

Chock
NOTE
For AWD models, refer to the section concerning special
handling instructions for AWD models in “INTRODUCTION
AND MASTER TROUBLESHOOTING”.
Take note of the following before inspection:
Assure tire pressure at standard value.
(Refer to GROUP
(2) When placing the vehicle on a speedometer tester drum,
make sure the center line of the vehicle is at right angles to
the center line of the drum. Also, make sure the drum is
positioned so as to center between the front tires.
Be sure to chock both rear wheels to prevent the vehicle
from moving. Secure the stoppers to the floor, or take
measures to prevent the stoppers from slipping.
(2) Make sure the parking brake has been set.
Attach anchoring bars on the tie-down brackets and secure
their ends to the anchor plates.
Make sure the tension on the right and left bars is the same.
Also be sure there is enough tension on each bar.
(1) Attach a chain or wire to the rear tie-down holes. Make
the end of the wire or chain is secured firmly.
Take all other necessary precautions.
Use a speedometer tester to measure the speedometer’s
indication error.