Mitsubishi MOTORS Laser 1991, Service Manual, Page: 13 / 320

Following procedures shall be followed for testing and
voltage at connector in order to prevent improper contact and
deterioration of waterproof in connector.
Check shall be done by inserting a probing needle from harness
side.
When terminal stopper of connector is out of order, engagement
of male and female terminals becomes improper even when con-
nector itself is engaged perfectly and terminal sometimes slips out
to rear side of connector. Ascertain, therefore, that each terminal
does not come off connector by pulling each harness wire.
Connector which gives loose engagement shall be rectified by
removing female terminal from connector housing and raise its
lance to establish securer engagement. Removal of
housing and raise its lance to establish securer engagement.
of connector terminal used for
and ELC 4 control
circuit
shall be done in the following manner.
screwdriver mm in.) width] as shown in the
figure, disengage front holder and remove it.