Mitsubishi MOTORS Laser 1991, Service Manual, Page: 159 / 320

STARTING SYSTEM
Place starter motor in a vise equipped with soft jaws and
connect a fully-charged battery
follows:
(2) Connect a test ammeter scale) and carbon
pile rheostat in series with batten/ positive post and starter
motor terminal.
(3) Connect a voltmeter scale) across starter motor.
(4) Rotate carbon pile to full-resistance position.
(5) Connect battery cable from battery negative post to starter
motor body.
(6) Adjust the rheostat until the battery voltage shown by the
voltmeter is (for the directdrive type) or IV (for the
reduction-drive type).
(7) Confirm that the maximum amperage is within the speci-
fications and that the starter motor turns smoothly and
freely.
Disconnect field coil wire from M-terminal of magnetic
switch.
(2) Connect a battery between M-terminal and body.
(3) Pull pinion out and release. If pinion quickly returns to its
original position, everything is in order. If it doesn’t, replace
magnetic switch.
Remove the knee protector.
(Refer to GROUP Panel.)
(2) Remove the relay from the underside of the relay box.
(3) Connect battery to terminal 2 and check continuity
b e -
tween terminals with terminal 4 grounded.
Power is supplied
terminals
I
N o c o n t i n u i t y
Power is not
supplied
terminals
2-4 terminals
Continuity
Continuity