Mitsubishi MOTORS Colt 2009, Owner'S Manual, Page: 74 / 449

Seat and seat belts
2-21
2
NOTE
● The pre-tensioner seat belts will be activated if the vehicle
suffers a severe frontal impact, even if the seat belts are
not worn.
●
The pre-tensioner seat belts are designed to work only
once. After the pre-tensioner seat belts have been acti-
vated, we recommend you to have them replaced by a
MITSUBISHI MOTORS Authorized Service Point.
SRS warning lamp
E00405900038
This warning lamp is shared by the SRS air bags and the pre-
tensioner seat belts.
Refer to “SRS warning lamp” on page 2-57.
Force limiter system
E00406000049
In the event of a collision, each force limiter system will effec-
tively absorb the load applied to the seat belt so as to minimize
the impact to the passenger.
WARNING
!
●
To obtain the best results from your pre-tensioner
seat belt, make sure you do the following:
• Adjust the seat to the proper position.
Refer to “Front seat” on page 2-5.
• Fasten your seat belt properly.
Refer to “Seat belts” on page 2-15.
CAUTION
!
●
Installation of audio equipment or repairs in the
vicinity of the pre-tensioner seat belts or floor con-
sole must be performed in line with MITSUBISHI
MOTORS guidelines. It is important to do so
because the work could affect the pre-tensioner sys-
tems.
●
If you need to scrap the vehicle, please consult a
MITSUBISHI MOTORS Authorized Service Point.
It is important to do so because unexpected activa-
tion of the pre-tensioner seat belts could cause inju-
ries.