Mitsubishi MOTORS Colt 2009, Owner'S Manual

Page: 218 / 449

Starting and driving
4-57
4
●
When the active stability control system (ASC) starts
operating. (if so equipped)
Refer to “Traction control system (TCL)/Active stability
control system (ASC)” on page 4-48.
Also, the set speed driving may be deactivated as follows:
● When the engine speed rises and approaches the tachome-
ter’s red zone (the red-coloured part of the tachometer
dial).
To resume the set speed
E00609800457
If the set speed driving is deactivated by the condition
described in “To deactivate” on page 4-56, you can resume the
previously set speed by pressing the “ACC RES” switch (C)
while driving at a speed of about 40 km/h or higher.
Under either of the following conditions, however, using the
switch does not allow you to resume the previously set speed.
In these situations, repeat the speed setting procedure:
●
The “ON OFF” switch is pressed.
●
The ignition switch is turned OFF.
●
“CRUISE” indicator lamp is turned OFF.
WARNING
!
●
On vehicles with AMT, although the set speed driv-
ing will be deactivated when shifting to the “N”
(NEUTRAL) position, never move the allshift lever
to the “N” (NEUTRAL) position while driving.
You would have no engine braking and could cause
a serious accident.
CAUTION
!
●
When the set speed driving is deactivated automati-
cally in any situation other than those listed above,
there may be a system malfunction.
Press the “ON OFF” switch to turn off the cruise
control and have your vehicle inspected by a MIT-
SUBISHI MOTORS Authorised Service Point.