Mitsubishi MOTORS Colt 2009, Owner'S Manual, Page: 37 / 449

1-6
Locking and unlocking
1
To unlock
Press the UNLOCK switch (2). All doors and the tailgate will
be unlocked.
If they are unlocked while the room lamp is not illuminated,
the room lamp will be turned on for approximately 15 seconds
and the turn-signal lamps will blink twice.
NOTE
●
If the UNLOCK switch (2) is pressed and any of the doors
or tailgate is not opened within approximately 30 seconds:
relocking will automatically occur.
●
It is possible to modify functions as follows:
For further information, contact your MITSUBISHI
MOTORS Authorized Service Point.
• The time from pressing of the UNLOCK switch (2) to
the moment of automatic locking can be changed.
• The confirmation function (flashing of the turn-signal
lamps) can be set to operate only when the doors and
tailgate are locked or only when the doors and tailgate
are unlocked.
• The confirmation function (this indicates locking or
unlocking of the doors and tailgate with the flash of the
turn-signal lamps) can be deactivated.
• The number of times the turn-signal lamps are flashed
by the confirmation function can be changed.
Operation of the Dead Lock System
With a vehicle that has a Dead Lock System, it is possible to
set the Dead Lock System using the remote controller.
(Refer to “Dead Lock System’’ on page 1-12.)
NOTE
●
With a vehicle that has a Dead Lock System, the keyless
entry system does not work while the key is in the ignition
switch.
●
Pressing the LOCK switch (1) has no effect (no locking
takes place) while a door or the tailgate is open.
●
The remote control switch will operate within about 4 m
from the vehicle. However, the operating range of the
remote control switch may change if the vehicle is located
near a TV transmitting tower, power station, or radio
broadcasting station.
●
If the turn-signal lamps flash nine times when you press
the remote control switch, the battery may have run down.
For further information, please consult your
MITSUBISHI MOTORS Authorized Service Point.
If you replace the battery yourself, refer to “Procedure for
replacing the remote control switch battery” on page 1-7.
●
If your remote control switch is lost or damaged, please
contact your MITSUBISHI MOTORS Authorized Service
Point for a replacement remote control switch.
●
If you wish to add a remote control switch, we recom-
mend you to contact your MITSUBISHI MOTORS
Authorized Service Point.
A maximum of 8 remote control switches are available for
your vehicle.