VS-50XL20U, VS-67XL20U, VS-50XLW20U
Set-up and Installation Manual
54
5. Insert a new lamp into the lamp chamber to the
end.
•
Do not touch the glass envelope of the
lamp with your fingers. The oil on your
fingers may cause damage or explosion of
the lamp.
•
Be sure to grip the handle with one hand
and hold the lamp with the other hand to
insert it safely. Be careful not to pinch your
hand in the lamp chamber.
6. Tighten the two lamp fixing screws.
7. Close the lower door.
8. After the replacement, perform “Condenser lens adjustment” (chapter 1.11, on page 62),
“Color balance adjustment” (chapter 1.5.4, on page 26) or “Picture outline adjustment”
(chapter 1.4, on page 14) as needed.
•
You don’t have to reset the lamp timer value since the lamp operating time is
automatically updated when lamp is replaced. As needed, you can reset it manually in
LAMP TIMER RESET in MAINTENANCE in the system menu.
•
If TERGET COLOR (chapter 1.5.4.6, on page 28) is set, the optimum color is adjusted
automatically after lamp replacement.
•
If SENSOR (chapter 1.5.4.7, on page 29) is set RUN, the brightness is automatically
adjusted to be uniform across a multi-screen.
Lamp fixing
screws