REV 1.4
21
1.5.2. Dipswitch
setting
Before turning on the main power switch, set the dipswitch correctly according to the system
configuration. Be sure to turn off the main power switch if you change the setting in the middle of
the operation. Only turning on the main power switch will renew the setting.
No.
Name
Function
Initial
setup
1
RC
Enabling remote control (ON: enabled, OFF: disabled)
ON
2 RESERVED
Normally
ON.
When
writing the firmware, set OFF.
ON
3 MASTER MASTER/SLAVE
setting
(ON: MASTER, OFF: SLAVE)
ON
4 ID5
OFF
5 ID4
OFF
6 ID3
OFF
7 ID2
OFF
8 ID1
Designating set ID number (1 to 32) (ON: 1, OFF: 0)
ID No.=1×(ID1)+2×(ID2)+4×(ID3)+8×(ID4)+16×(ID5)
Example:
ID No.=1: ID1=ON, ID2, ID3, ID4 and ID5=OFF
ID No.=32 :ID1, 2, 3, 4 and 5=OFF
ON
1.5.3. System set up
Set the “system memory” to suit the system as shown below. The parameters are effective for all
the input memories and display memories.
Press and hold [MENU2] button to display the system memory menu. You can exit the menu by
[ESC] button.
1.5.3.1. LAMP POWER
Used to set brightness mode.
You can select NORMAL or BRIGHT. Normally set NORMAL. BRIGHT mode can make high bright
display. In this case, the lamp life becomes shorter than NORMAL mode.
[Procedure]
1. Select LAMP POWER in MISC FUNCTION in the system menu.
2. Set NORMAL or BRIGHT.
1.5.3.2. LAMP MODE
Used to set lamp-driving system.
You can select LONG LIFE, NORMAL or F-REDUCTION. Normally set F-REDUCTION.
•
F-REDUCTION: It drives with lamp flicker reduction.
•
LONG LIFE: It drives with longer lamp life than F-REDUCTION mode even though the flickers
may occur.
•
NORMAL: it automatically change F-REDUCTION and LONG LIFE mode.
[Procedure]
1. Select LAMP MODE in MISC FUNCTION in the system menu.
2. Set F-REDUCTION, LONG LIFE or NORMAL.
1.5.3.3. TERMINATE
Used to select the termination of analog input synchronizing signal in the main unit.
You can select 75 or 1K. Normally set 1K (1K
Ω
termination). If the synchronization is lost while
5-line (separate sync) signal inputs to the analog input terminal in the main unit, set this item to
75 (75
Ω
termination). The image may be displayed correctly.
[Procedure]
1. Select TERMINATE in MISC FUNCTION in the system menu.
2. Set 75 or 1K.
RESERVED
MASTER
ID5
ID4
ID3
RC
ID2
ID1
OFF ON
1
2
3
4
5
6
7
8
