REV 1.4
45
1.7.5.6. SCALING FILTER
Used to set the scaling filter in the input board signal. If jagged character outlines are noticeable,
setting “1” or “2” makes it smooth. “2” makes softer image. Setting “0” sharpens the displays,
especially when displaying high resolution image such as UXGA signal or scaled down images.
The initial setting is 1.
[Procedure]
1. Select SCALING FILTER in the menu 1 (page 2).
2. Adjust the value by left/right buttons.
1.7.5.7. COLOR (When COMPOSITE or Y/C is input)
Used to adjust the color depth of the image. [NORMAL] button can reset it to the factory setting.
[Procedure]
1. Select COLOR in the menu 1 (page 3).
2. Adjust the value by left/right buttons.
1.7.5.8. TINT (When COMPOSITE or Y/C is input)
Used to adjust the hue of the image. It is effective only for NTSC signal. [NORMAL] button can
reset it to the factory setting.
[Procedure]
1. Select TINT in the menu 1 (page 3).
2. Adjust the value by left/right buttons.
1.7.5.9. SHARPNESS (When COMPOSITE or Y/C is input)
Used to adjust to sharpen or soften the image. Be noted that increasing the value excessively
causes noise on the image. [NORMAL] button can reset it to the factory setting.
[Procedure]
1. Select SHARPNESS in the menu 1 (page 3).
2. Adjust the value by left/right buttons.
1.7.5.10. VCR MODE (When COMPOSITE or Y/C is input)
Used to set the VCR mode ON when an image from a particular VCR cannot be displayed
correct colors. Normally set OFF.
[Procedure]
1. Select VCR MODE in the menu 1 (page 3).
2. Select ON or OFF.
