Mitsubishi Electric PUZ-HA24NHA1, Service Manual

Page: 120 / 128

120
OCH750A
15-5-3. PAR-SL100A-E
Fig. 15-1
Fig. 15-3
Fig. 15-2
Fig. 15-4
1. Going to the function select mode
Press the button between of 5 seconds.
(Start this operation from the status of remote controller display turned off.)
[CHECK] is lit and "00" blinks. (Fig. 15-1)
Press the button to set the "50".
Direct the wireless remote controller toward the receiver of the indoor unit and
press the button.
2. Setting the unit number
Press the button to set unit number
A
. (Fig. 15-2)
Direct the wireless remote controller toward the receiver of the indoor unit and
press the button.
3. Select a mode
Press the button to set Mode number
B
. (Fig. 15-3)
Direct the wireless remote controller toward the receiver of the indoor unit and
press the button.
Current setting number: 1=1 beep (1 second)
2=2 beep (1 second each)
3=3 beep (1 second each)
4. Selecting the setting number
Use the button to change the Setting number
C
. (Fig. 15-4)
Direct the wireless remote controller toward the receiver of the indoor unit and
press the button.
5. To select multiple functions continuously
Repeat select
3
and
4
to change multiple function settings continuously.
6. Complete function selection
Direct the wireless remote controller toward the sensor of the indoor unit and
press the button.
Note: Be sure to write down the settings for all functions if any of the initial
settings has been changed after the completion of installation work.
A
B
C