Mitsubishi Electric PLFY-WP VBM-E, Data Book

Page: 99 / 192

2 - 10
R2
MEE15K052
1. SPECIFICATIONS
Model PURY-EP300YLM-A1 (-BS)
Number of HBC controller Single HBC Double HBC
Power source 3-phase 4-wire 380-400-415 V 50/60 Hz
Cooling capacity *1 kW 33.5
(Nominal) kcal/h 28,800
*1 BTU/h 114,300
Power input kW 12.05 10.24
Current input A 20.3-19.3-18.6 17.2-16.4-15.8
EER kW/kW 2.78 3.27
Temp. range of Indoor W.B. 15.0~24.0°C (59~75°F)
cooling *3 Outdoor D.B. -5.0~46.0°C (23~115°F)
Heating capacity *2 kW 37.5
(Nominal) kcal/h 32,300
*2 BTU/h 128,000
Power input kW 11.71 11.12
Current input A 19.7-18.7-18.1 18.7-17.8-17.1
COP kW/kW 3.20 3.37
Temp. range of Indoor D.B. 15.0~27.0°C (59~81°F)
heating *3 Outdoor W.B. -20.0~15.5°C (-4~60°F)
Indoor unit Total capacity 50~150% of outdoor unit capacity
connectable Model/Quantity WP15~WP50/3~30
Sound pressure level (measured in anechoic room) dB <A> 62.5
Sound power level (measured in anechoic room) dB <A> 86
Refrigerant High pressure mm (in.) 19.05 (3/4) Brazed
piping diameter Low pressure mm (in.) 22.2 (7/8) Brazed
FAN Type x Quantity Propeller fan x 1
Air flow rate m
3
/min 230
L/s 3,833
cfm 8,121
Control, Driving mechanism Inverter-control, Direct-driven by motor
Motor output kW 0.92 x 1
*4 External static press. 0 Pa (0 mmH
2
O)
Compressor Type Inverter scroll hermetic compressor
Manufacture AC&R Works, MITSUBISHI ELECTRIC CORPORATION
Starting method Inverter
Motor output kW 8.1
Case heater kW -
Lubricant MEL32
External finish Pre-coated galvanized steel sheets (+powder coating for -BS type)
<MUNSELL 5Y 8/1 or similar>
External dimension H x W x D mm 1,710 (1,650 without legs) x 1,220 x 740
in. 67-3/8 (65 without legs) x 48-1/16 x 29-3/16
Protection devices High pressure protection High pressure sensor, High pressure switch at 4.15 MPa (601 psi)
Inverter circuit (COMP./FAN) Over-heat protection, Over-current protection
Compressor -
Fan motor -
Refrigerant Type x original charge R410A x 8.0 kg (18 lbs)
Control HBC controller
Net weight kg (lbs) 244 (538)
Heat exchanger Salt-resistant cross fin & aluminium tube
HIC circuit (HIC: Heat Inter-Changer) -
Defrosting method Auto-defrost mode (Reversed refrigerant cycle, Hot gas)
Drawing External WKJ94T757
Wiring WKE94G041
Standard attachment Document Installation Manual
Accessory Refrigerant conn. pipe
Optional parts Main HBC controller: CMB-WP108, 1016V-GA1
Sub HBC controller: CMB-WP108, 1016V-GB1
Remarks Details on foundation work, duct work, insulation work, electrical wiring, power source switch, and other items shall be referred
to the Installation Manual.
Due to continuing improvement, above specifications may be subject to change without notice.
Notes: Unit converter
1.Nominal cooling conditions (subject to JIS B8615-2)
Indoor: 27°CD.B./19°CW.B. (81°FD.B./66°FW.B.), Outdoor: 35°CD.B. (95°FD.B.)
Pipe length: 7.5 m (24-9/16 ft.), Level difference: 0 m (0 ft.)
2.Nominal heating conditions (subject to JIS B8615-2)
Indoor: 20°CD.B. (68°FD.B.), Outdoor: 7°CD.B./6°CW.B. (45°FD.B./43°FW.B.)
Pipe length: 7.5 m (24-9/16 ft.), Level difference: 0 m (0 ft.)
3.-5°CD.B. (23°FD.B.)/-6°CW.B. (21°FW.B.) to 21°CD.B. (70°FD.B.)/15.5°CW.B. (60°FW.B.)
with cooling/heating mixed operation.
4.External static pressure option is available (30 Pa, 60 Pa/3.1 mmH
2
O, 6.1 mmH
2
O).
BTU/h =kW x 3,412
cfm =m
3
/min x 35.31
lbs =kg/0.4536
*Above specification data is
subject to rounding variation.
0000003904.BOOK 10 ページ ２０１６年１月２５日 月曜日 午後２時３１分