REV 2.5
43
1.5.1.12. AUTO POWER ON
Used to set automatic turning on when the main power is supplied. The initial setting is OFF.
•
ON: Automatic turning on when the main power is supplied.
•
OFF: When the main power is supplied, the product takes over the last memory status. For
instance, it becomes stand-by state if the main power was turned off in stand-by state.
Likewise, if it was turned off in the state of power on, it automatically turns on.
[Procedure]
1. Select AUTO POWER ON in MISC FUNCTION in the system menu.
2. Set ON or OFF.
1.5.1.13. BLOWOUT (for
X
X
L
L
2
2
1
1
or when the input board is attached in
P
P
H
H
5
5
0
0
and
X
X
L
L
5
5
0
0
)
This adjustment is normally unnecessary.
Used to select digital output status after lamp blowout. The initial setting is OPERATE.
•
OPERATE: After lamp blowout, it maintains the digital output function. Set OPERATE when
the digital out is used for the digital daisy chain connection.
•
SHUTDOWN: After lamp blowout, the product starts shutdown. Set SHUTDOWN for a single
screen or a display wall without digital daisy chain connections.
[Procedure]
1. Select BLOWOUT in MISC FUNCTION in the system menu.
2. Set OPERATE or SHUTDOWN.
1.5.1.14. EXTENDED ID
Used to set the ID number 33 or higher. The initial setting is NORMAL.
•
NORMAL : The set ID can be set 1 to 32 by dipswitch (chapter 1.4.2, on page 30).
•
ID:33–64 : The set ID can be set 33 to 64. When the ID is set 1 by the dipswitch, it is
automatically recognized as 33 in this mode.
[Procedure]
1. Select EXTENDED ID in MISC FUNCTION in the system menu.
2. Set NORMAL or ID:33–64.
Summary of Contents for PH50 series
Page 122: ......
