Mitsubishi Electric NZ2MFB1-32D, User Manual

Page: 17 / 126

3 SPECIFICATIONS
3.1 General Specifications
15
3
3
SPECIFICATIONS
This chapter describes the specifications of the I/O module.
3.1
General Specifications
*1 Do not use or store the I/O module under pressure higher than the atmospheric pressure of altitude 0m. Doing so may cause
malfunction. When using the I/O module under pressure, please consult your local Mitsubishi representative.
*2 When the programmable controller is used at altitude above 2000m, the withstand voltage performance and the upper limit of the
operating ambient temperature decrease. Please consult your local Mitsubishi representative.
*3 If the environment satisfies the operating ambient temperature, operating ambient humidity and other conditions, the module can be
used even outside the control panel.
*4 This indicates the section of the power supply to which the equipment is assumed to be connected between the public electrical power
distribution network and the machinery within premises.
Category

applies to equipment for which electrical power is supplied from fixed facilities. The surge voltage withstand level for up to
the rated voltage of 300V is 2500V.
*5 This index indicates the degree to which conductive material is generated in terms of the environment in which the equipment is used.
Pollution degree 2 is when only non-conductive pollution occurs. A temporary conductivity caused by condensing must be expected
occasionally.
To ensure that this product complies with the EMC Directive, refer to the following.

Page 108 EMC and Low Voltage Directives
Item Specifications
Operating ambient temperature 0 to 55 
Storage ambient temperature -25 to 75 
Operating ambient humidity 5 to 95%RH, non-condensing
Storage ambient humidity
Vibration resistance Compliant with JIS
B 3502 and IEC
61131-2  Frequency Constant
acceleration Half amplitude Sweep count
Under intermittent
vibration 5 to 8.4Hz  3.5mm 10 times each in X,
Y, and Z directions
8.4 to 150Hz 9.8m/
 
Under continuous
vibration 5 to 8.4Hz

1.75mm

8.4 to 150Hz 4.9m/
 
Shock resistance Compliant with JIS B 3502 and IEC 61131-2 (147m/  , 3 times each in X, Y, and Z directions)
Operating atmosphere No corrosive gases, flammable gases, less conductive dust
Operating altitude
*1
0 to 2000m
*2
Installation location Inside a control panel
*3
Overvoltage category
*4
 or less
Pollution degree
*5
2 or less
Equipment class Class
