Mitsubishi Electric F930GOT-BWD, Operation Manual

Page: 102 / 342

Graphic Operation Terminal GOT-F900 Screen mode 9
9-12
Basic operation
• A key window will always open in the same position as it was last closed, even if the screen
is changed over and back again. If the window is displayed for the first time, it will appear in
its set position.
• On a screen for which the key window initial position is not set, the window is always
displayed in the lower right corner.
• When a key windows initial position is set to where it is protruding from the screen, the initial
position start coordinate is corrected so that the entire key window can be displayed on the
screen. (Refer to the figure below.)
Zero point (0, 0)
X:0
Y:100
When "X: 0, Y: 100" are set
The zero point in this coordinate system is located at
the upper left corner of the screen. •
"X: 300, Y: 220" are set
Coordinates are
automatically corrected
to "X: 160, Y: 100"
When "X: 160, Y: 100" or larger coordinates are set
In the following setting,
the key window is
protruding from the
screen. •
The upper left corner coordinates are
automatically corrected so that the
entire key window can be displayed on
screen. •