Mitsubishi Electric EHWT17D-MHEDW, Data Book

Page: 89 / 131

Check the maximum reach of the cable and install the bracket with
screws.
<Notice>
● Do not overtighten the screws.
►The bracket may deform or break.
● When installing the bracket, select an interference-free space.
►Keep the installing area at least 10 cm away from metal or a wall box. If unable to do so, always place the room wire -
less remote controllers in locations where the communication test determines that the wireless remote controllers are
fully capable of communication with the wireless receiver.
● Do not install the bracket with screws on the exterior casing of the cylinder unit.
► The internal parts may be damaged, which could result in breakdown of the indoor unit.
● Do not install the bracket where the receiver could be exposed to moisture or leaked water from piping connec -
tions above.
► The wireless receiver subjected to moisture could cause electric shock, fire, or its breakdown.
When installing the wireless receiver, observe the following.
● Keep the other electric or electronic devices (e.g. radio, induction
heating cooker, microwave oven, refrigerator, and mobile phone
or the like) at least 50 cm away from the wireless receiver.
● Place the wireless receiver in an interference-free area and keep
the wireless receiver away from metal.
Do not excessively pull the cable when measuring the maxi -
mum reach .
Place the wireless receiver on the fixed bracket.
Hook the holes on the back of the wireless receiver onto the projec-
tions on the bracket, and fix the wireless receiver.
<Notice>
● Do not place the wireless receiver inside the hydrobox.
►Both the wireless receiver and its wire may break due to heat inside the indoor unit.
● Do not pull the cable excessively.
►Breakdown, ignition, or fire may result.
● Do not have the wireless receiver suspended.
►Breakdown, ignition, or fire may result.
Hold the front panel with the screws.
Optional parts
D-18
ATW Wireless System
2
Optional parts