Notes:
Any person at the following places cannot be detected.
● Along the wall on which the air conditioner is installed.
● Directly under the air conditioner.
● Where any obstacle, such as furniture, is between the person and
the air conditioner.
A person may not be detected in the following situations.
● Room temperature is high.
● A person wears heavy clothes and his/her skin is not exposed.
● A heating element of which temperature changes significantly is
present.
● Some heat sources, such as a small child or pet, may not be sensed.
● A heat source does not move for a long time.
The 3D i-See sensor operates once approximately every 3 minutes
to measure the floor temperature and detect persons in the room.
● The intermittent operating sound is a normal sound produced when
the 3D i-See sensor is moving.
Notes:
●
During swing operation, the directional indication on the screen
does not change in sync with the directional vanes on the unit.
●
Available directions depend on the type of unit connected.
●
In the following cases, the actual air direction will differ from the
direction indicated on the remote controller display.
1. While the display is in “STAND BY” or “DEFROST” states.
2. Immediately after starting heat mode (while the system is wait-
ing for the mode change to take effect).
3. In heat mode, when room temperature is higher than the tem-
perature setting.
3.7. Ventilation
For LOSSNAY combination
■
The following 2 patterns of operation is available.
• Run the ventilator together with indoor unit.
• Run the ventilator independently.
Notes: (for wireless remote controller)
●
Running the ventilator independently is not available.
●
No indication on the remote controller.
3.6.4. Seasonal airflow function
1
Select the setting with the [F4]
button.
OFF → Cooling only → Heating
only → Cooling/Heating → OFF…
After changing the setting, press
the [SELECT] button to save the
setting.
OFF: The function is disabled.
Cooling only: When the thermostat
turns off during cooling mode, the
vanes move up and down.
Heating only: When the thermostat
turns off during heating mode,
the vanes move to the horizontal
airflow direction to circulate the air.
Cooling/Heating: The function is
enabled during both cooling mode
and heating mode.
* In order to enable this function,
the airflow direction must be set
to “Auto”.
Seasonal airflow
Select:
Seasonal airflow
Cooling/Heating
F1
F2
F3
F4
3. Operation
3
When No occupancy Auto-OFF is
selected
Set the time with the [F2] or [F3]
button.
―: The setting is disabled
(the operation will not stop
automatically).
60 – 180: The time can be set in
10-minute increments.
4
The message at left will appear
if the operation was stopped
automatically by the No
occupancy Auto-OFF setting.
Energy saving option
Select:
Time
No occupancy Auto-OFF
min.
120
F1
F2
F3
F4
18:47 Thu
Shut down by
No Occupancy Auto-OFF
31/Dec AM12:59
F1
F2
F3
F4
12
en
RG79F455H01_en.indd 12
2019/07/15 9:13:14
014
