Mitsubishi Electric CITY MULTI PLFY-M-VEM Series, Operation Manual

Page: 12 / 40

3. Operation
■
Manual vane angle (Wireless remote controller)
Fig. 3-1
A
Fig. 3-2
B
Fig. 3-3
1
Going to the Manual vane setting
mode
Press the button.
(Start this operation from the
status of remote controller
display turned off.)
“FUNCTION” is lighted and “1”
blinks. (Fig. 3-1)
Press the button to select “2”,
and then press the button.
2
Selecting the vane number (Fig.
3-2)
Press the buttons to select
the vane number
A
, and then
press the button.
3
Setting the vane angle (Fig. 3-3)
Press the buttons to select
the vane angle
B
.
Point the wireless remote
controller toward the receiver on
the indoor unit, and then press
the button.
4
Press the button to
complete the settings.
Display
Setting Step 1 Step 2 Step 3 Step 4
Display No display
Setting Step 5 No setting Draft reduction*
* The draft reduction can be set for only 1 vane.
The setting is enabled only for the last vane that was set.
3.6. 3D i-see Sensor setting
Note:
This function cannot be set depending on the outdoor unit to be
connected.
3.6.1. 3D i-see Sensor setting
Operation
Main Main menu
F1 F2 F3 F4
1
Select “Operation” from the Main
menu, and press the [SELECT]
button.
Cursor
Operation
Vane·Louver·Vent. (Lossnay)
High power
Comfort
Main menu:
F1 F2 F3 F4
2
Select “Comfort” from the
Operation menu, and press the
[SELECT] button.
3
Select “3D i-See sensor” with the
[F1] or [F2] button, and press the
[SELECT] button.
4
Select the desired menu with the
[F1] or [F2] button, and press the
[SELECT] button.
• Air distribution
Select the airflow direction
control method when the airflow
direction is set to “Auto”.
• Energy saving option
Operates the energy-save mode
according to whether persons are
detected in the room by the 3D
i-see Sensor.
• Seasonal airflow
When the thermostat turns off,
the fan and the vanes operate
according to the control settings.
3D i-See sensor
Cursor
Setting display:
Air distribution
Energy saving option
Seasonal airflow
F1 F2 F3 F4
Comfort
Cursor
Manual vane angle
3D i-See sensor
Setting display:
F1 F2 F3 F4
F1 F2 F3 F4
Manual vane angle
Return:
M-NET address
Function setting for unit
with vane fully open.
F1 F2 F3 F4
Manual vane angle
Return:
No communication
Check Unit state.
2
After pressing the [F4] button,
wait approximately 15 seconds,
and then check the current state
of the air conditioner.
→ The vane is pointing
downward. → This air conditioner
is displayed on the remote
controller.
→ All outlets are closed. →
Press the [RETURN] button and
continue the operation from the
beginning.
→ The messages shown to the
left are displayed. → The target
device does not exist at this
refrigerant address.
• Press the [RETURN] button to
return to the initial screen.
3
Change the “M-NET address” to
the next number.
• Refer to step
1
to change the
“M-NET address” and continue
with the confirmation.
10
en
RG79F455H01_en.indd 10 2019/07/15 9:13:14
012