OPERATING PROCEDURE
PHOTOS & ILLUSTRATIONS
34
12. Removing the Auto vane
(1) Remove the intake grille. (See Figure 1, 2)
(2) Remove the right side panel. (See Figure 3)
(3) Remove the vane motor and cover. (See Photo 13)
(4) Slide the auto vane to the vane motor side.
(5) Remove 2 axes from each vane support pushing the
vane support to the vane sleeve side.
11. Removing the guide vane
(1) Remove the intake grille. (See Figure 1, 2)
(2) Remove the side panel (right and left). (See Figure 3)
(3) Remove the under panel. (See Photo 14)
(4) Remove the drain pan. (See Photo 15, 16, 17)
(5) Remove the screw from the guide vane, then remove
the guide vane.
10. Removing the pipe thermistors / Liquid (TH22) and Gas
(TH23)
(1) Remove the air intake grille. (See Figure 1, 2)
(2) Remove the left and right side panels. (See Figure 3)
(3) Remove the under panel. (See Photo 14)
(4) Remove the drain pan. (See Photo 15, 16, 17)
(5) Disconnect the connector CN44 (white) from the indoor
controller board.
(6) Remove 6 screws from the pipe cover and remove the
pipe cover. (See Photo 15, 18)
(7) Remove the fastener for wires and remove the thermistors
(liquid and gas) from each holder. (See Photo 19)
Photo 18
Gas pipe
thermistor
Liquid pipe
thermistor
Pipe cover
Pipe cover fixing
screws
Pipe cover fix-
ing screws
(See Photo 15)
Fastener
Photo 20
Photo 19
Screw
Guide vane
Drain pan
Photo 21
Vane supports
Vane
Vane sleeve
Vane motor side
OCH449A
