41 LSH Electric Logsplitter
19
Original Instructions Version August 19
17. Troubleshooting
The table below contains a list of error symptoms and explains what you can do to solve the problem if
your tool fails to work properly. If the problem persists after working through the list, please contact your
nearest service workshop.
PROBLEM
PROBABLE CAUSE
REMEDY SUGGESTED
Motor stops starting
Overload protection device
disengaged to protect the log
splitter from being damaged
Contact a qualified Electrician.
Fails to split logs
Log is improperly positioned
Refer to" Log Splitter Operation"
section for perfect log loading
The size or hardness of the log
exceeds the capacity of the ma-
chine
Reduce the log size before split-
ting it on the log splitter
Wedge cutting edge is blunt
Refer to " Sharpening Wedge"
section to sharpen the cutting
edge
Oil leaks
Locate leak(s) and contact the
dealer
The log pusher moves jerkily, making
unfamiliar noises or vibrating a lot.
Lack of hydraulic oil and exces-
sive air in the hydraulic system
Check oil level for possible oil
refilling. Contact the dealer
Oil leaks around cylinder ram or from
other points.
Air sealed in hydraulic system
while operating
Loosen Bleed Screw by 3-4 rota-
tions before operating the log
splitter
Bleed Screw is not tightened
before moving the log splitter
Tighten the Bleed Screw up be-
fore moving the log splitter
Oil Drain Bolt with Dipstick is not
tight
Tighten the Oil Drain Bolt with
Dipstick
Hydraulic Control Valve Assem-
bly and / or seal(s) worn
Contact your dealer