41 LSH Electric Logsplitter
13
Original Instructions Version August 19
4
3
g
3. Now fasten the guards (E + F) on the top. Fasten
them with eight Phillips head screws, clamping
brackets and nuts.
4. Fasten the guards (E + F) together using two
Phillips head screws, clamping brackets and nuts.
IMPORTANT!
You must fully assemble the appliance before using it
for the first time!
10. Initial operation
Before start-up, place the splitter on a stable, level and flat workbench so that the splitter tray table sits
at a height of 72 - 85 cm. If the machine should slip during splitting work, fasten it to the table with two
screws (M8 x X = thickness of the table). To do so, use the two holes on the foot (16).
Make sure the machine is completely and expertly assembled. Check before every use:
• the connection cables for any defective spots (cracks, cuts etc.).
• the machine for any possible damage.
• the firm seat of all bolts.
• the hydraulic system for leakage.
• the oil level and
• the safety devices
10.1 Checking the oil level (Fig. 15)
The hydraulic unit is a closed system with oil tank, oil
pump and control valve. Check the oil level regularly
before every use. Too low an oil level can damage
the oil pump. If the oil level is at the lower notch, then
the oil level is at a minimum. Should this be the case,
oil must be immediately added. The upper notch indicates
the maximum oil level. The machine must
be on level ground. Screw in the oil dipstick fully, to
measure the oil level.
MAX
MIN
