29
Indicator Display
Possible Cause/Rectification
no lights or beeps
problem with electrical supply.
1.
Make sure there is power to the appliance.
2.
reset the shower.
3.
Contact qualified electrician to investigate
the cause.
Shower temperature is not hot enough.
Maximum temperature is set too low.
1.
adjust Maximum Temperature, refer
to section:
'set Maximum showering
Temperature and Commissioning
Cycle'
.
OR
problem with incoming water supply. hose or
showerhead blocked. Temperature is too high and/
or pressure is too low.
1.
Water supply may correct itself within a few
minutes.
2.
The showerhead may be blocked, refer to
the fault diagnosis section in your shower
fittings installation and user guide.
3.
The shower hose is kinked or blocked.
4.
If the warning persists during further use,
check all isolator valves are fully open and
reset/recommission the shower.
5.
If the warning still persists, there is a
problem with the water supply. contact a
competent tradesperson who can further
investigate the cause.
OR
automatic shutdown to protect against unsafe
showering. caused by problem with either the
appliance or the electrical/water supply.
1.
reset the shower.
appliance has been incorrectly shut down.
1.
on restart and for safety reasons, the
appliance will complete a second cold purge
of the tank followed by normal operation.
The
start/stop
button will pulse for 30
seconds to indicate the appliance is in
recovery mode (This will only happen in
non beab care mode settings).
