Minuteman ROS 17 ORB 115V, Use And Maintenance Manual

Page: 32 / 76

29
EN
To insert the brush/pad holder into the brush head body of the
appliance, proceed as follows:
1. Check that the plug (1) on the power cable (2) has been taken
out of the socket (3) of the mains supply (
)LJ
), and if not,
disconnect it.
ATTENTION: You are advised to always wear protective
gloves, to avoid the risk of serious injury to your hands .
ATTENTION : To prevent damaging the power cable,
disconnect the plug from the mains socket by directly pulling
the plug and not the cable.
2. Check that the handlebar is in the vertical position, if not, press
the uncoupling lever (4) (
)LJ
) and turn the handlebar to the
vertical position (
)LJ
). When the handlebar is vertical, release
the uncoupling lever (4).
PREPARATION OF THE APPLIANCE
INSERTING THE BRUSH
3. Tip the appliance back (
)LJ
), block one of the rear wheels and
shift the control column backwards.
4.
8QVFUHZDQGUHPRYHWKH¿[LQJOXJVDQGFHQWHULQJSODWH )LJ
).
To insert the solution tank onto the handlebars, proceed as follows:
1. Secure the handlebar in a position at about 45° with respect to
the ground (
)LJ
).
2. Unscrewing the closing knob (1) (
)LJ
) position the upper
brackets beyond half of the column (
)LJ
) (if it has not already
been positioned).
INSERTING THE SOLUTION TANK
3. Put the solution tank on the column, so that the bottom of the tank
LVDQFKRUHGWRWKH¿[HGEUDFNHWRQWKHFROXPQLWVHOI )LJ
).
4. Holding the tank with one hand, move the mobile bracket (3)
down until the solution tank is locked to the column (
)LJ
).
5. Lock the position of the mobile bracket (3) by tightening the
closing knob (1) (
)LJ
).
6. Insert the water distribution pipe (4) in the hole on the brush head
(5) (
)LJ
).
5. Turn the brush anti-clockwise to secure it to the
hub (
)LJ
). Insert the drive disc, be careful to
center the fastening pins on the machine with the
drive holes. Then insert the centering plate and
WKHQVFUHZGRZQWKH¿[LQJNH\VVHFXUHO\
29
1
2
3 4
1
4
2
5
3
6
1 2 3
1