Parts and Instruction Manual
Page 7
1
Dirt hopper control lever
2
Latch
3 Bar for dirt hopper wheels
4 Dirt hopper
•
Depress lever (1) to the right to unlock
•
Hold dirt hopper by its handle (3) and
pull to the rear, empty hopper
•
Slide dirt hopper into opening, exert
pressure against latch (2) until click is
audible, to ensure the dirt hopper is
installed in place.
Traction Drive
The traction drive system uses a friction wheel (1) and a V-belt (2) driving the wheel axle.
When actuating the traction drive control lever, the friction wheel arm (3) with its friction wheel
(1) is pressed against the drive shaft (7), thus allowing power transmission. Note: dust
extractor fan and side broom will rotate as soon as motor is running. Keep hands and fingers
away from any moving parts to avoid injury
1. Friction wheel
2. V-belt
3. Friction wheel arm
4. Cocking roller for broom roller drive
5. V-belt for broom roller drive
6. Control cable for friction wheel arm
7. Drive shaft for traction drive, broom
roller and side broom drive assy’s.
Replace Broom Roller
The broom roller bears 10 rows of bristles and consists of 4 halves. A new broom is 9.8" dia. (250mm).
The broom roller should be replaced when reaching a dia. of 9" (230 approx. mm) to function properly.
To remove the broom roller:
Tilt the Kleen Sweep 35W back on the handlebar, as shown. Remove 4 ea. cylinder Hexagon screws,
rotate roller through 180, and remove cylinder Hexagon screws from the other half. Pull drive pin out of
broom shaft. For installation, reverse the above sequence of operations.
Empty Dirt hopper
To Order Parts Call 1-888-702-5326 - https://monsterfloorequipmentparts.com
