Parts and Instruction Manual
Page 8
Adjust Sweeping Track
In case of broom roller wear and after replacing the roller broom, adjust sweeping pattern as follows:
•
Start the machine and rotate broom roller for a short period of time (static)
•
Lift front end of machine and pull back.
•
If adjusted properly, a parallel line of sweep is visible on the ground (sweeping track). This
sweeping track width is adjusted to approx. 2" (50 mm) by rotating the hand wheel CW or
CCW. Sealing strips (1 to 4) have to be inspected for wear in regular intervals and replaced
as required. Sealing strips slightly should touch the ground.
1. Sealing Strip, Forward
2. Sealing Strip, Right Hand
3. Sealing Strip, Rear
4. Sealing Strip, Left Hand
5. Broom Roller
1 side broom attaching bolt
2 round belt for side broom drive
3 V-belt for broom roller drive
Replacing the Side Broom
•
Tilt the Kleen Sweep 35W back on its handlebar (also refer to previous section, “replace
broom roller”)
•
Remove attaching bolt (1) underneath side broom
•
Pull-off side broom
•
Plug-on new side broom and secure; torque attaching bolt light tight only, to avoid
damage to the broom hub.
To Order Parts Call 1-888-702-5326 - https://monsterfloorequipmentparts.com
