film winds onto the take-up spool, it
pushes forward a lever inside the take-up
chamber. The lever then moves the film-
advance indicator from left to right in Fig.
28. You can see the film-advance in
dicator through the w indow at the back
of the top cover.
Check the film-advance indicator after
you replace the retaining ring around the
wind shaft. Fig. 24. Reach to the front of
the take-up spool and push forward the
lever that extends into the take-up
chamber; the film-advance indicator
should move into the w indow . If the film-
advance indicator doesn't move, loosen
the retaining ring. Fig. 24. Then hold fo r
ward the lever inside the take-up chamber
so that you can see the film-advance in
dicator w ithin its window. Continue
holding the lever as you tighten the re
taining ring.
To replace the w ind lever, first hook its
hole to the end of the wind-lever return
spring. Then rotate the wind lever in a
counterclockwise direction as you seat it
over the wind shaft. The upper coil of the
w ind lever return spring sometimes
sneaks under the wind lever. If that hap
pens, the wind lever w o n 't return freely
after you replace the cover screw.
The film-speed dial can also be tricky to
install. Replace the exposure-compensation
lever and the detent rack as shown in Fig.
29; notice that the slot in the exposure-
compensation lever fits over the tab on the
film-speed resistor ring. Then replace the
black plastic decorator ring. Fig. 25. The
notch in the decorator ring goes under the
exposure-compensation lever.
S P E E D K N O B
R E T A I N I N G R I N G
T O P C O V E R
R E T A I N I N G R I N G
M O D E S E L E C T O R
Figure 24
mmo
E X P O S U R E C O M P E N S A T I O N
L E V E R /
L O N G T O P - C O V E R
S C R E W S
I
D E T E N T
P L A T E
F R O N T -
D E C O R A T O R
P L A T E
v
U P P E R
B R A S S
B U S H I N G
D E C O R A T O R
R I N G
Figure 26
E Y E P I E C E - B L I N D L E VE R
T O P - C O V E R
S C R E W -----
M O D E S W I T C H
IN M M O D E
A M O D E
Figure
